Select “ Change adapter settings” in the left side column of Network and Sharing Center.There you can see your newly created network under the original network connection.Go to control Panel -> Network and Internet and select Network and Sharing Center.Sharing your Wireless Network Adapter Step 1: If your Command Prompt says ” your hosted network couldn’t be started ” then make sure to turn on the “ WiFi” and also enable the Wireless Adapter :) Command : netsh wlan start hostednetwork.You have successfully established the Network Connection. You can use your own parameters for SSID and KEY and Password must be greater than 8 digits. Note: In this example, I have used my own user Name and Password.Type “ netsh wlan set hostednetwork mode=allow ssid=yourname key=yourpassword” (enter the command without the quotations).Configuring the Hosted network connection: Step 1:
If the result is “YES” then proceed to Step 3 or else download the required drivers from your vendor website. Type the following command in Command Prompt.
And that’s what we call a “ WiFi Hotspot“. If you are away from your home network and do not access to your internet connection, you will probably require some of your friends or colleagues internet to share their network access and connect through a common gateway. At the same time, sharing of resources on the Internet has been triggered between Wireless Routers or Mobile WiFi Hotspots. In the 21 st century, the utilization of the internet is increasing day by day. In order to reduce the difficulty, it’s better to establish a WiFi Hotspot using Command Prompt. It requires a particular software which gives the ability to host a Hotspot in our computer.
A WiFi Hotspot is a Wireless hub which offers a network access to various devices over a wireless medium using routers.